---
title: "Alarm System Installation Services"
description: "Browse all our security services. From cameras and smart locks to system repair and maintenance, we schedule the visit."
canonical: "https://www.houstontxhomesecuritysystems.com/services"
lastmod: "2026-10-05T11:37:55.362Z"
---

# Alarm System Installation Services

From alarm installation to camera setup, smart locks, and carbon monoxide detectors, we arrange the full range of residential and small-business security work.

## Alarm System Installation Services

From alarm installation to camera setup, smart locks, and carbon monoxide detectors, we arrange the full range of residential and small-business security work.

- **[Access Control System](https://www.houstontxhomesecuritysystems.com/services/access-control)**: The installer fits an electric strike or magnetic lock at each entry point and pairs it with a keypad, card reader, or fob reader. User credentials are programmed per person, access schedules are set, and the entry log is confirmed active so you can see who entered and when from day one.
- **[Alarm System Installation](https://www.houstontxhomesecuritysystems.com/)**: Your control panel, door and window contacts, motion sensors, and siren are fitted in a single visit. Cellular backup keeps central-station monitoring active even during a power or internet outage, and every sensor is signal-tested before the job closes.
- **[Carbon Monoxide Detector Installation](https://www.houstontxhomesecuritysystems.com/services/co-detector-installation)**: The installer maps every fuel-burning appliance and sleeping area in your home, then fits UL-listed CO detectors at each required location, including near gas furnaces, water heaters, and attached garages. Hard-wired or battery units are selected based on your home’s wiring, and each detector is sensor-tested before the job closes.
- **[Motion Sensor Installation](https://www.houstontxhomesecuritysystems.com/services/motion-sensors)**: The installer identifies the highest-value choke points, hallways, stairwells, and main entries, then mounts each passive infrared sensor at the correct height and angle for full coverage. Wiring is matched to your existing switch configuration, including 3-way setups, and a walk-test confirms no blind spots remain.
- **[Security Camera Installation](https://www.houstontxhomesecuritysystems.com/services/camera-installation)**: Your property is assessed for blind spots, then indoor and outdoor cameras are mounted with concealed cable routing and weatherproof housings rated for Houston’s heat and humidity. NVR or app-based remote viewing is configured and tested so footage is recording correctly before the visit ends.
- **[Security System Maintenance](https://www.houstontxhomesecuritysystems.com/services/system-maintenance)**: The maintenance visit covers a zone-by-zone sensor trigger test, backup battery voltage check, camera view and recording confirmation, keypad function test, and a monitoring connection reset if needed. Any component showing a fault is flagged with a specific finding, not a general advisory, before the visit closes.
- **[Security System Repair](https://www.houstontxhomesecuritysystems.com/services/system-repair)**: The installer reads panel error codes, runs a zone-by-zone sensor signal test, checks backup battery voltage, and traces camera connection faults to the source. Each component is tested individually so the fix targets the actual fault, not a blanket reset that leaves the underlying problem in place.
- **[Security System Replacement](https://www.houstontxhomesecuritysystems.com/services/system-replacement)**: The installer identifies the faulty component from the panel display or symptom, sources the correct replacement part by model number, including 12V 7Ah backup batteries and wireless sensor units, and runs a post-swap system test to confirm the trouble light clears and every zone reports correctly.
- **[Smart Lock Installation](https://www.houstontxhomesecuritysystems.com/services/smart-lock)**: Your door’s backset and thickness are measured before the electronic deadbolt is fitted, then the strike plate is adjusted for clean latch engagement. Keypad pairing and app access are tested on-site, and a deadbolt throw test confirms the bolt seats fully in the strike plate before the job closes.
- **[Smoke Detector Installation](https://www.houstontxhomesecuritysystems.com/services/smoke-detector-installation)**: The installer plans detector positions to meet NFPA 72 and Houston Fire Code requirements, then hardwires and interconnects units so every alarm sounds when one triggers. A post-installation alarm test confirms each detector activates correctly and the interconnect chain fires across the whole home.
- **[Video Doorbell Installation](https://www.houstontxhomesecuritysystems.com/services/video-doorbell)**: The installer checks your existing doorbell wiring and transformer voltage before choosing wired or wireless power. The camera is mounted at the correct angle on brick, siding, or trim, and the job closes only after a live ring test, confirmed Wi-Fi signal, and working motion alerts on your phone.

## Get a Written Quote for Your Alarm Install

You receive a written estimate listing every component and its cost before any work is scheduled.

[Request Your Estimate](https://www.houstontxhomesecuritysystems.com/contact)

## Business details

### Contact

- **Email**: [contact@houstontxhomesecuritysystems.com](mailto:contact@houstontxhomesecuritysystems.com)
- **Based in**: Houston, TX, 77002
- **Enquiries**: [Send an enquiry](https://www.houstontxhomesecuritysystems.com/contact) — We ask for your name, phone number, email and a message.

### Opening hours

- **Monday**: 08:00 – 18:00
- **Tuesday**: 08:00 – 18:00
- **Wednesday**: 08:00 – 18:00
- **Thursday**: 08:00 – 18:00
- **Friday**: 08:00 – 18:00
- **Saturday**: 10:00 – 16:00
- **Sunday**: 10:00 – 16:00
